Deluxe Driveway Alert ELR Instructions

INFRA RED SENSOR OPERATION
The infrared detector is positioned behind the round lens. It has a horizontal detection angle of 40 degrees. The effective detection range of the sensor is from 0 feet to 30 feet, with 10 feet being the optimum range.

The infrared sensor detects vehicles, intruders, guests etc., by sensing their heat and motion. When someone or something moves through the detection zone, the sensor detects the intrusion and transmits a signal to the receiver.

INFRA RED SENSOR INSTALLATION
First, install a high quality, 9 volt, alkaline battery in the compartment located in back of the sensor. Securely close the battery cover.

Mount the sensor approximately 2-2 1/2 feet above the ground to a tree, wooden post or side of a building. A metal bracket is provided. The lens must have an unobstructed view of the coverage area. Extend the flexible antenna upward. Some objects may not be detected if the sensor is placed too high or too low. Adjusting may be required prior to calling for technical support. Keep the sensor as close to the edge of the driveway as possible.

The sensor should be strategically located so that it detects objects moving across detection zone. Do not mount the sensor facing the sun, bodies of water or any reflections. This causes variations in the temperature pattern "seen" by the sensor and may cause false alarms or damage the lens.

PLEASE NOTE: A shorter transmission range may occur when the outside temperature falls below 20 degrees F. due to a natural drop in battery voltage. Lower sensitivity may occur during periods of fog, rain or snow. This is due to the moisture diffusing the infrared energy. The sensor/transmitters are rated to -40 degrees F.

RECEIVER OPERATION
Plug the transformer into a 110 volt, indoor outlet. Stand receiver up or mount to wall and attach the rigid antenna to the connector on the receiver.

The receiver will sound the alert when the sensor is activated. The alert sound re-sets itself on the 6th second and will continue to alert you with every intrusion. The volume control can be used to change the sound level. The light emitting diode will light when the receiver is activated and will remain lit until the button is manually reset.

The receiver comes equipped with an accessory jack for the easy addition of accessories adding to the versatility of this deluxe system.

In unobstructed space, the reception range can reach up to 2500 feet. Range may be reduced by certain obstructions. For instance; metal buildings, dense woods, etc. For maximum range, locate the receiver in an area in your home with some direct visibility to the sensor.

WALK TEST
After setting up your system perform a "walk" test to ensure the operation. Walk and drive through the detection area and have someone listen for the receiver to sound. The sensor then can be re-positioned if not properly performing.

CODING ADJUSTMENT
The system coding is factory pre-set and should be adjusted only in the event of interference from another source. A DIP switch is located in each the sensor and receiver. Only the first five positions on the switches can be changed and the switch settings in the transmitter must match the settings in the receiver.

TROUBLESHOOTING
As with all passive infrared devices certain weather conditions and other acts of nature may cause false alarms or reduce sensitivity. Below is a list of the most common problems and the solutions to solve them.

PROBLEMS can be caused by

  • Use of a low quality or non-alkaline battery
  • Use of an old, weak battery
  • The sun shining into the sensor lens
  • The sun reflecting off shiny objects
  • An improperly mounted or poorly secured sensor

SOLUTIONS

  • Replace battery with a new, high grade alkaline
  • Position the sensor so it has a clear view
  • Re-position sensor away from direct sun rays
  • Mount and secure sensor properly
  • Read and follow the "Infra Red Sensor Installation" and "Receiver Operation" sections, correct problem and perform "Walk Test" to verify operation